If a competitor’s pick up does not work at an event, a competitor may be hand tached immediately after leaving the track after a competitive pass. The pick- up MUST be in working order during competition. The cord must have a factory female end at the plug end. The cord must run outside of transmission blanket and all sheet metal. The cord must be visible from the point of pick up to the rear of the vehicle. The cord must be wired uninterrupted to the rear of the vehicle and is to be mounted on the back of the vehicle directly above the drawbar area. Absolutely no drawbar supports designed to pull only from, or to be attached only to a point above the centerline of the rear axle.ĥ) Angel of draw bar is to be no greater than eleven degreesġ) SFI approved clutches and flywheels are required.ġ) Each competing vehicle must have a working RPM pick up on their vehicle.
Drawbar must be equipped with a steel hitching device not more than 1.5 x 1.5 square, (or 1.5 round), and with an oblong shaped hole 3.75 inches long and 3 inches wide.Ģ) No drawbar support tubes attached above the centerline of the rear axle, unless using the stock drawbar support for that make and model. This includes the area of the pin with the pin removed. 1) Drawbars shall meet the following: drawbar to be a minimum of 2 square inches total steel material at any point.
0 kommentar(er)
